So the Balun is on the Centerpiece, Now we want to connect the Balun to the Dipole Side.
Cut the outerside of the Coax Cable from the Cable like shown on the Picture. Note that you should not cut too wide in the Wire.
When you are finished it should look like on the picture.
Now use a needle or a small screwdriver to open the outer Conductur of the Coax wire. You do want to take your time on this step. Be carefull so you dont break the outer conductor.
When you are finished wind the outer conductor around and make it nice ant tight.
Cut it about the same lengh as the inner conductor.
Put some heatshrink on the outer Conductor and on the point where the 2 Conductors meet on the Coax cable.
Get yourself 2 6mm Cable connectors and solder them on the ends of the 2 Wires.
When you have finished soldering, take 2 x 6mm Screws with a lengh of about 15-20mm, 4 washers and 2 nuts.
Just put them on the Centerpiece as shown, We need to put the Dipole wires later on the Centerpiece.
Best wishes
Hoonse